Crashing Printing Reports

5 posts / 0 new
Last post
B
Crashing Printing Reports

I am using v6.1.0.0, the most up to date version available to me. PGSuper is crashing when I try to print a detailed report. I originally had this issue trying to convert a v5.0.2 to v6.1.0.0. I started over in v6.1. I'm able to print a few girders' details reports, but when I try and print a girder in span 3 specifically PGSuper crashes. Is this a known issue?

Thanks

AttachmentSize
Binary Data 3 Span Bridge418.88 KB
bricer
Crashing Printing Reports

That is not a known issue. I tried to print a few reports using your file and was successful. I used the "Microsoft Print to PDF" driver.

One user reported crashes with printing to PDFs with the BlueBeam driver.

Crashes in the print drivers are not within the scope of PGSuper so there isn't much we can do about that.

If you have additional details, we can look into the problem further.

B
I was a little unclear. It

I was a little unclear. It crashes when I try to open the details report for any of the girders in span three of the attached .pgs. If it works on your machine, I guess I'll try starting over...Thanks for looking at it.

B

B
Figured It Out

Just in case someone else has this same issue: The reason PGSuper crashed trying to load the details report was because (for some unknown reason) the bearing geometry, under Edit Girder, was set to "Bearing Data is unique at the end of every girder".

When I change this option to "Bearing data is the same for the entire Bridge", it no longer crashes when loading the details report.

Weird and I have no idea...

B

Rick Brice
Figured It Out

Thanks for following up on this. The issue has been corrected in the Version 7.0 Beta 0 release.

Log in or register to post comments